22010 Autoloader 2 ALE2: Drum Position does not agree with target, possible drum error ThermoFlex During the unload sequence, the operator must lift the Trailing Edge of the media and then get the drum to jog towards the table by moving the flash cover away from its open position. Should the media start to get caught under the table edge (or a finger etc.) the operator can open the flash cover to stop the drum and retract it back to the trailing edge position. This will cause this error to pop up, suspending the machine until the user wishes to continue. This will also pop up if the drum position at the end of the jog (without the flash cover re-opened) does not agree with the original target position. If everything is ok, click resume and try unload jog again. The current drum position does not agree with a target position set in the MPE firmware. Currently this is only reported during an unload when the operator opens the flash cover during the drum jog. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:50 2008 PST